On-site Inspection and repair on WGW KSHK 1330 S/So gearbox

This client from THE NETHERLANDS came to us with this WGW KSHK 1330 S/So. We inspected the gearbox and performed a repair. After a succesful testrun we shipped the gearbox back to the client.

Scope of work:

- Cleaning, inspection and assembly
- Renewing bearings, seals and various small materials
- Test run with test run protocol
- Update the gearbox internally and remove, sand, degrease and conserve externally
- Transport

Additional work following from inspection:

- Applying oversized dowel pins.
- The mechanical minimum clean-up of distance rings and spacer for renewal of the conical pinion shaft
- Inbound conical pinion shaft for pre-machining, capping and naming the seal
- Manually check inside gear teeth
- Offset hollow shaft (pos.9) in connection with seal on both sides, material 42CrMo4
- Renovate the bronze canister (2 pieces) for outgoing hollow shaft
- Renew labyrinth ring outgoing side
- Renew the breather cap (2 pieces)
- Renew the dipstick
- Applying a splash plate for the breather cap
- Renew the adjusting bolts (4 pieces) with nuts