Inspection and repair project of BUSS G-1600

Inspection and repair of BUSS G-160 gearbox

BUSS gearbox
G-160
Input=___ rpm / ____ KW

Scope of work:

We performed an inspection and repair on a gearbox BUSS G-160.

A client from Netherlands came to us with this BUSS G-160 gearbox. We investigated the unit and did a total overhaul. After the revision was succesfully done, we did a test run and prepared the gearbox to be shipped back to this client.

The work consisted of:

The line bore measurement shows that the rear bearing has a skew position of -0.58 mm. The rear dust can could not be measured properly as the mixer was not completely closed and was therefore not in the correct position. The rest of the measured positions are within acceptable values.

The skew of the rear bearing could possibly be corrected. Since there are currently no problems with this bearing, this does not have a high priority.

The line through the rear dust can can be checked again when the mixer (without shaft) is completely closed. We recommend this at the moment when there are problems with the dust canister.